First Aid Method for Damage to Undercarriage in Crane Chassis Parts

First Aid Method for Damage to Undercarriage in Crane Chassis Parts

In case of damage to chassis parts when the crawler crane is in the field or away from the maintenance site, the following emergency methods can be used to lift the crane to the position where the equipment is repaired.

1.    Brake wheel cylinder, brake fluid leakage or broken pump pipe road, can be in pump pipe road junction with iron, copper sheet to make a small cushion, blocking the pipeline, then tighten the screws, or fracture clip flat, crimp leakage. However, this may cause unilateral braking and safety in driving.

      2. The friction blade of small crane clutch is ablated and skidded, which can be used for the friction film with less serious ablation. If the ablating is serious, the cotton cloth or the canvas number layer (the thickness should be the same as the original friction plate), the steel wire or wire shall be used to pass through the hole in the steel sheet to make it fixed. When driving a equipment, it should start smoothly and move quickly.

      3. Tie rod ball failure, in the bumper or other places do not affect driving, unload a similar to ball joint total length of screw, instead of the failure of ball joint, steering knuckle arm fitted with nut, the bolt showing a good with a hammer riveting.

Above is our summary of crane chassis parts, chassis parts damaged when first aid methods are available, and if you have any different ideas or opinions, or enquiry about our undercarriage parts of crawler crane, welcome to contact us to further discuss and correct us, thank you for your attention.