Four-wheel factory for you to solve common problems of crawler crane
Crawler Crane is one kind large equipment that we often use, but the crawler will make some problems, four-wheel area manufacturers will introduce these solutions of the problem for you:
1, Update steel cord: original commonly used for steel cord phi 0.25 mm x 7 mm x 7 mm, now switch to phi after 0.22 mm x 7 mm x 12 mm, tensile strength increased obviously.
2, Iron tooth loss: the phenomenon generally characterized by iron teeth from rubber tracks.
When the improvement mainly from the increase bonding area, without any increase in iron teeth under the premise of quality, improve the iron cross section shape of the tooth, thus increasing and the bonded area of the rubber tracks, at the same time also more appropriate iron tooth surface roughness, in order to increase iron teeth stick relay of rubber.
Four-wheel area manufacturer to tell you that this improvement is the product of inertia in the iron teeth increase more, bending strength has been improved obviously.
3, Iron tooth fracture: fracture location is usually occur in the junction of the driving wheel and the iron teeth.
Four-wheel area factory tell you feet deep in the mud turn difficulties or through high ridge machine load is bigger, as the most likely to cause tooth fracture phenomenon of iron.To improved iron tooth structure, can greatly increase the strength of the iron teeth, improve the durability of the iron teeth.
If you are looking for manufacturer of four-wheel area for you on the problem and not understand of place, hope you can put forward in time, we will specifically for you, you will be with you to discuss the corresponding problems.