Crane chassis manufacturer to introduce crane chassis parts of traditional fault system
Crane chassis parts by the transmission, driving system, steering system and brake system and so on four big system, the role of the chassis is supporting, installation car engine and its parts, assemblies, form the car overall modelling, and accept the power of engine, chassis problems are common, crane chassis parts of traditional fault as follows:
1,
crane accessories clutch fault, the most common fault is a step on the
clutch, shift is difficult, but let go after flameout, gear at the same
time accompanied by sound.Inspection method: clutch bottom cover will be
removed, idling, will step on bottom of the clutch, driven plate with
all tools, can BoZhuan, shows good;Otherwise, the separation is not
completely.
Commonly
used solution is: using the measuring tool measuring free stroke, if is
too large, the turn to adjust the clutch adjusting nut; Open the clutch
bottom cover, check whether separation lever within the end of the high
and low.
For a small crane accessories double disk clutch, elimination
method is; Upon separation fork, let the front end of the release bearing
against the separation lever in the end, then, clutch rotation week,
carefully check, if the separation can contact with the release bearing
can't lever in the end, is the separation of the height of the lever is
not unified, need to adjust.
If separation lever highly unified, the
separation is not complete, need to check the height of the lever.
If the new lining thickness, adding in the clutch and the flywheel thickness suitable gasket, to keep their balance.
2,
common fault with gear transmission failure, the oil heating, there was
a noise, etc.Gear failure is jumping gears, gears, etc.Connection
between the transmission and clutch screw loose.
We
can check the common solution is to: remote operation of transmission
between joystick, transmission and clutch set screw. Open the
transmission and check the transmission gear, check the sliding gear and
the second axis spline fit. Screening fork shaft locking
devices. Transmission and dismantling, bearing and gear and bearing
fit. Check if the first axis in the transmission and engine crankshaft
synchronization.
Above is the crane chassis manufacturer introduce crane chassis parts of traditional fault system. A good chassis can ensure the safety of the driver's life, so you must do a good job of chassis parts inspection and maintenance, are looking forward to your coming.