A. Track shoe for Sumitomo SC700-2 crawler crane Production Process：
1.Make Mold---2.Sand Mold---3.Casting---4.Polishing Riser Milling---5.Quenching & Tempering---6. Hardness & Mechanical Properties Test ---7. Surface Quenching ---8Painting---9Package
B. Track shoe for Sumitomo SC700-2 crawler crane Advantage --- Heat Treated
1. All casting should be Austenitized at 900°C for one Hr per every inch of casting thickness.
2. Then Quenched on water and Tempered for sufficient amount of temperature and time.
3. All heat treatment should be carried out after castings reach temperature lower than 200°C.
The general hardness after QT to be 230-320 BHN.
C. Track shoe for Sumitomo SC700-2 crawler crane Package in the below
D. Hot products for Sumitomo SC700-2 crawler crane as following:
1. Track Shoe/Track Pad/Track Plate/Crawler Trend /Crawler Pad/Crawler Plate/Crawler Treads/Crawler Belts/Bottom Plate/Chain Pads/Grouser Shoe for Sumitomo SC700-2 crawler crane
2. Track Roller / Bottom Roller / Lower Roller for Sumitomo SC700-2 crawler crane
3. Top Roller / Carrier Roller / Upper Roller for Sumitomo SC700-2 crawler crane
4. Sprocket / Drive Sprocket / Driving Tumbler for Sumitomo SC700-2 crawler crane
5. Idler / Idler Assy / Idler Tumbler / Front Idler for Sumitomo SC700-2 crawler crane
E. About installation
Track shoe for Sumitomo SC700-2 crawler crane should be installed in the same direction to form the belt of the head and tail. In this way, the operation uniformity is good, the wear of Track shoe for Sumitomo SC700-2 crawler crane is low, and the driving efficiency is high when walking.
Hot Tags: track shoe for sumitomo sc700-2 crawler crane, manufacturers, suppliers, dealer, quality, OEM